laser-1-13.jpg
Viewed: 64 times.
|
9 - Attach the red wire from the laser to the center terminal on the switch and solder.
Viewed: 68 times.
|
laser-1-15.jpg
Viewed: 62 times.
|
10 - The finished assembly. Almost ready to put it all back together.
Viewed: 49 times.
|
Laser on!
Viewed: 49 times.
|
11 - If your laser is too small for the mounting bracket you wrap it with tape to bulk it out. This is better than just globing on glue since it will keep the laser as close to center as possible.
Viewed: 43 times.
|
12 - Slide the laser into the bracket and hot glue it in place. To keep the leads out of the way temporarily tape them out of the way.
Viewed: 52 times.
|
laser-1-20.jpg
Viewed: 52 times.
|
13 - Now we need to remove the old lense. It barely worked with the LED and gives a football shaped image with the laser. If you wanted to you could replace it with a piece of plastic or a one of the covers that came the laser. I didn't do it on this one but the next one will project a skull and crossbones.
Viewed: 43 times.
|
laser-1-22.jpg
Viewed: 48 times.
|
laser-1-23.jpg
Viewed: 52 times.
|
Quick Firefly CPVC Mod - 1/2" CPVC insert cut to 1/4" thick and pressed into the end of the turret. The rings tighten the barrel and guarentee a tight fit on any dart.
Viewed: 54 times.
|
